This PDF book Structure
and Signal Path Analysis for Analog and Digital Circuits covers the following
topics related to Analog and Digital Circuits : Introduction, State of the Art,
Enhanced Building Block Analysis, Structural Signal Path Analysis, Symmetry
Computation, Application: Input Data Generation for Timing Characterization,
Application: Constraint Generation for Analog Circuits, Conclusion.
design and test IC analog components, and building blocks in CMOS technology.
Topics covered includes: Phase Margin Parameters, Linearity Metrics, Op Amp
Limitation SR, GB, 3dB Time Constant Computation, Conventional Op Amp Design,
Multi-Loop Gm-C Amplifiers, Nested Gm-C Amplifiers, Noise Fundamentals,
Common-Mode Feedback, Low Voltage Cells, Buck Drien and Bulk Bias, Floating Gate
Circuits, Class-D Amplifiers, Line Drivers, Multipliers Linearized OTAs,
Negative Impedance Converter, Rail-To-Rail Amplifiers.
The focus of this note is
on data converter design both Nyquist-rate and oversampling converters. Topics
covered includes architectures, noise-analysis, as well as amplifier, comparator
and DAC sub-blocks.
note covers the following topics: Operational Amplifier, Difference Amplifiers,
Biasing of Differential Amplifiers, Practical Operational Amplifier, Parameters
of an OPAMP, Open loop OPAMP Configuration, Closed Loop Amplifier, Voltage Shunt
Feedback, OPAMP Applications , Oscillator, Harmonic Oscillators, Tuned
Oscillators, Voltage Regulators, Design of Series Voltage Regulator, Series
regulator with Current Pre-regulator.
This note explains the following topics:
Frequency Response, SPICE , Operational Amplifiers, Summing Amplifier Revisited,
Frequency Responses and Active Filter Circuits, Combination Notch and Bandpass
Filter, CMRR, Reverse Biased Capacitance, Small Signal Diode Models, BJT Circuit
Analysis, dc Bias Point Calculations, Common Collector Amplifier, IC
implementations, Diode-connected BJT.
This book explains the following topics: DC Biasing - BJTs, voltage
feedback, Bias stabilization, Design of bias, Small Signals Modeling of BJT and
their analysis, DC Biasing of FETs, Signal Modeling and Analysis of FETs, System
Approach-Effects of RS and RL, BJT and JFET Frequency Response, Compound
Configurations, Compound Configurations, Barkhausen Criterion of oscillation,
Oscillator operation, Power Amplifiers, Operational Amplifiers and operation,
op. amp. Applications.
Author(s): Veer Surendra Sai University of
This lecture note covers the
following topics: Elementary Electronic Circuits with a Diode, Elementary
Electronic Circuits with a BJT Transistor and FET Transistor, Biasing Transistor
Circuits, Double-Transistor Circuits, Negative Feedback in Single-Transistor
Circuits, Positive-Feedback Oscillators and High-Frequency Response.
This note covers the following topics: Analog and Amplifiers,
Limits and Class Prejudice, Frequencies and Filters, Power Supplies, Wires and
Cables, Transmission and Loss, Op-Amps and their uses, Valves and Thermionic